(This step does not apply for HMC managed partitions.) Take the option to Recover configuration data. Take the option to Work with system partitions. Select Option 1.Īfter the installation of LIC is complete, the system will IPL to the DST primary menu.
#Gdisk wipe all disks install#
The first menu will give an Option 1 to Install LIC, and Option 2 to use DST.
#Gdisk wipe all disks manual#
Steps 5, 6 and 7 below do not pertain to HMC managed partitions.ĭo a D Manual IPL using a SAVSYS, full system save, or LIC Install CD of the primary partition. On HMC partitions the procedure must be done to each partition because they are independent of each other. Note: This is true only for legacy systems that use a Primary partition. Legacy Partitioned System (systems that use a Primary partition) : (If this is a legacy system with a primary partition, this will remove all partitions and erase all data on drives from all earlier partitions.) When that is complete, power off the system. Note: If using the LIC Install CD (I_Base) to install LIC, the default password for QSECOFR will be uppercase QSECOFR. Type 1 in front of all the available units. This writes zeroes on the disk drives so only the LIC is loaded. Note: Data still remains on the disk units until the following steps are completed.Īfter the installation of LIC is complete, the system will IPL to the DST primary menu (IPL or Install the System).Ĭonfigure all the disk drives by adding them into system ASP (ASP 1). Select Option 2 to Install Licensed Internal Code and Initialize System. The Install LIC menu will provide five options. The first menu will give an Option 1 to Install LIC, Select Option 1. Stand-alone system or HMC managed partition or one Secondary partition:ĭo a D Manual IPL using a SAVSYS, full system save, or LIC Install CD. If a system is being scratched with the intention to return a system or discontinue use, RAID can be stopped on the LS RAID set prior to initialization to decrease the time the scratch process will take.Ĭhoose one of the methods below to erase all data from the system or partition: Note: The initialization of the Load Source (LS) can take hours to complete. They may want to do this because they are discontinuing the system or just performed a Disaster Recovery test and want to destroy or remove all data on the system. In some cases, a customer may wish to erase all data off their system.
#Gdisk wipe all disks how to#
This document describes how to remove all data from your DASD on partitioned and stand alone systems.
0 kommentar(er)
